Laying Cutting Wire Around Windscreen:

Starting from pull-in point, lay wire eyelet created on the outside counterclockwise around the windscreen.
Pull excess wire into car interior.

IMPORTANT: Make sure the cutting wire is located at all four corner points below the windscreen. Check that the cutting wire is not caught on retainers or body. Secure window on outside with adhesive tape against slipping

Fig 1: Ensuring The Cutting Wire Is Located At All Four Corner Points Below The Windscreen

NOTE: Windows (1) with fitted seals (3) or sprayed-on surrounds:

Moisten cutting wire (4) and seals (3) on window (1) with water.
Insert cutting wire (4) in bend (without kinking) between window (1) and body cutout (2).

Fig 2: Inserting Cutting Wire In Bend