61 13 ... Crimping annular contacts

Crimpac II crimping pliers from repair kit 1 are used to crimp annular contacts.

Fig 1: Identifying Crimping Pliers

Open crimping pliers (1).

NOTE: Place contact (2) in designated nest (observe wire crosssection) with particular care. Make sure it is exactly positioned.

Insert annular contact (2) in crimping pliers (1).

Fig 2: Inserting Annular Contact (2) In Crimping Pliers (1)

Close crimping pliers (1) gently and keep closed.

NOTE: Follow procedure for cutting and stripping insulation from cables.

Feed stripped cable (1) into annular contact (2) completely.

Close crimping pliers (3) fully.

Open crimping pliers (3) and remove cable (2).

Fig 3: Opening Crimping Pliers And Removing Cable

NOTE: Check contact for correct crimping.