51 24 100 Removing and installing/replacing trunk lid lock (upper section of trunk lid lock)

Lift out Omega clip (1).

Disconnect connector (2).

Fig 1: Identifying Omega Clip And Connector

Lift out actuating rod (1).

Unfasten screws and remove upper section of trunk lid lock.

Fig 2: Replacing Trim For Trunk Lid

Installation:

Perform function check with trunk lid open.

Adjust upper section of trunk lid lock as necessary.

Only replace:

Lift out actuating rod (1).

Cut through cable connector (2) and remove micro-switch (3).

Fig 3: Identifying Actuating Rod And Micro-Switch