Windlass With Double Coil:
For use with small windows.
- Attach windlass firmly to window so that both coils are turned away from application point of wire.
- Feed either the upper wire end into the lower coil or the lower wire end into the upper coil.
- Fit reversible ratchet on coil and tension wire.
- Cut through approx. 10 cm of bonding joint.
- Feed other wire end into free coil so that the wires cross.
- Continue cutting bonding joint by alternately using the coils.
- Both wires meet ahead of both coils when removal is completed.
- Remove "Roll Out 2000".