Test Connections:

Multifunction cable 1  (with two leads) is used to test all multimeter functions not requiring special sensors. MFK 1 is used to measure:

• Voltage - up to 50 Volts
• Current - up to 2 Amps
• Resistance
• Diode Testing
• Frequency
• Period
• Duty Cycle
• Pulse Duration
  Fig 2: Identifying Test Connections (MFK2)

  

Multifunction cable 2  (with four leads) MFK 2 is used to measure:

• Voltage - up to 500 Volts
• Frequency
• Period
• Duty Cycle
• Pulse Duration

When selecting the 1000A current measurement function, the current probe will be the default test connection. The current probe is self calibrating.

When selecting the pressure measurement function, the pressure sensor will be the default test connection. The reading will begin at approximately 1 Bar (the reading cannot be zeroed).

When selecting the temperature measurement function, the temperature sensor will be the default test connection. The reading is only provided in degrees Celsius.

Type of measurement:  Various measurements require defining the type of signal measured.

DC: Set to test a direct current signal.

AC: Set to test for an alternating current signal.

Displays a measured AC wave form as the RMS (root-mean-square) value. The RMS value is the DC equivalent of the voltage or current produced by an AC wave form.

Measuring Range:  Sets scale range for selected measurement.

Scale will automatically range to the best suitable range.

Arrows are provided for the user to manually set range of measurement.