Installation (Except M3)

Installation is reverse of removal. Draw in new wheel bearing with Special Tool (33 4 041/ 042/ 043/ 047). For 42 mm inner bearing race, use Special Tool (33 4 049) and for 39 mm inner bearing race, use (33 4 046). See Fig 1.
Replace stretched or damaged circlip. Ensure correct seating.
Pull in drive flange using Special Tool (33 4 041/ 042/ 043/ 045/ 048). See Fig 2.
Install brake disc.
Install axle shaft.

Fig 1: Pulling In New Wheel Bearing

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Pulling In Drive Flange

Courtesy of BMW OF NORTH AMERICA, INC.