51 24 100 Removing and installing/replacing rear lid lock (upper section)

Remove panel for rear lid.

Convertible only:

Remove additional brake light.

Unclip plug connection (1) in direction of arrow from cover fastener and disconnect.

Loosen screws (2).

Unclip cover fastener (3) in direction of arrow.

Fig 1: Uncliping Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Ensure retaining lugs (1) are correctly seated.

Place Bowden cable (2) in mount (3).

Feed plug (4) as illustrated through opening.

Ensure catches (5) are correctly seated.

Fig 2: Identifying Retaining Lugs Are Correctly Seated

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1).

Release screws (2) and feed out upper section of rear lid lock (3).

Fig 3: Feeding Out Upper Section Of Rear Lid Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Use thread-tapping screws.

Remove lock (1).

Lever out actuating rod (2) and remove upper section of rear lid lock (3).

Fig 4: Removing Upper Section Of Rear Lid Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Perform function check with trunk lid open.