12 41 020 Removing and installing/replacing starter motor (M62): Notes
Switch off ignition.
NOTE:
Follow instructions for disconnecting and connecting battery, refer to
General Information MG 12.
Disconnect battery negative lead from battery.
Remove reinforcement plate. Refer to FRONT AXLE SUPPORT .
Remove protective cap (1) of battery positive lead from starter motor.
Release nut (2).
Tightening torque, see 12 41 4AZ in ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .
Disconnect battery positive lead (3) from starter motor.
Unclip battery positive lead from holders.
Release nuts (1).
Tightening torque, see 12 41 4AZ in ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .
Detach leads (2) from starter motor.
Release screws.
Tightening torque, see 12 41 1AZ in ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .
Pull starter motor out of transmission mount and remove.