Principle Of Operation: Initialization: Procedure
After the new motor has been recoded in the normal manner, the procedure that must be used is as follows:
- Push the sunroof button in the up (tilt) direction and hold. After approximately 20 seconds the sunroof panel will make a small down-up movement.
- Release the button for no more than 5 seconds and push and hold it in the up (tilt) direction again.
- The roof will run through a full open and close cycle. Once this cycle is completed, the initialization and adaptation is complete.
NOTE:
If the motor runs in the wrong direction when pushing the button in the up (tilt) direction, preventing proper initialization, get the sunroof to the closed position, and disconnect power to the motor for about 15 seconds. Reconnect the motor and start the initialization procedure again, and it should work properly.
Anti-Trap Feature: The anti-trap feature of the sunroof uses a hall sensor to detect obstructions while the sunroof is closing (pulse frequency slowed down) in the automatic close function. The anti-trap feature is shut down prior to full closing, about 4 mm from full closed, to allow the sunroof to seat into the seal.
NOTE:
The anti-trap feature is not functional when the switch is held in the manual close position.