51 24 Rear lid locks
REAR LID LOCKS TIGHTENING SPECIFICATION
| Type | Thread | Tightening Specification | Measure | |
|---|---|---|---|---|
| 1AZ Banjo bolt to hydraulic unit and to hydraulic cylinder | E39/Touring | 10+2.5 N.m | ||
| E65/E66/E67 | 14.5 +/- 1.5 N.m | |||
| 2AZ Oil filler plug to hydraulic unit | E65/E66/E67/E39/Touring | 8+2 N.m | ||
| E61 | 1+0.3 N.m | |||
| 3AZ Engine bolt to hydraulic unit | E65/E66/E67 | 5+1.5 N.m | ||
| 4AZ Hydraulic unit to bracket | E61 | 2+1.5 N.m | ||
| E65/E66/E67 | 10 N.m | |||
| 5AZ Rear lid lock to rear lid | E65/E66/E67/E87/E90 | 10 N.m | ||
| E91 | 20 N.m | |||
| 6AZ Striker to body | E65/E66/E67/E87/E90/E91 | 10 N.m | ||
| 7AZ Bracket, hydraulic unit, to body | E65/E66/E67 | 10 N.m | ||
| 8AZ Bracket, angle sensor, to body | E65/E66/E67 | 7 N.m | ||
| 9AZ Valve to hydraulic unit | E65/E66/E67 | 14 N.m | ||
| 10AZ Fastener to rear lid | E90 | 10 N.m | ||
| 11AZ Ball pin for hydraulic cylinder to body | E61 | Install with Loctite 270 | 41 N.m |