35 41 421 Replacing bowden cable for throttle valve actuation: Notes

Remove cover from left wiper blade, refer to 67 52 510 REMOVING AND INSTALLING OR REPLACING CONTACT PRESSURE ADJUSTER .

Remove lower left trim from instrument panel.

Disconnect Bowden cable.

Fig 1: Disconnecting Bowden Cable

Lift off covers (1).

Unfasten nuts (2).

NOTE: If applicable, remove grommet for Tempomat Bowden cable.

Remove manifold cover.

Fig 2: Lifting Off Covers

Remove Bowden cable with rubber grommets from end panel.

Fig 3: Removing Bowden Cable With Rubber Grommets From End Panel

Unfasten Bowden cable from bracket for manifold cover (1).

Fig 4: Unfastening Bowden Cable From Bracket For Manifold Cover

Press both lugs of nipple bearing together and press out of actuating lever.

Fig 5: Pressing Both Lugs Of Nipple Bearing Together And Pressing Out Of Actuating Lever

Pull out Bowden cable towards rear of vehicle.

Remove rubber buffer from holder.