34 11 000 Removing and installing/replacing brake linings on both front disk brakes: Notes
Special Tools Required:
NOTE:
For Special Tools, see BRAKE - SPECIAL TOOLS - 740i & 740iL - E38
.
- 34 1 050
- 34 1 080
NOTE:
After completing work:
- Fully depress brake pedal several times so that brake linings contact brake diskcs.
- When installing new brake linings at front and rear axles, brake fluid level must be brought up to "MAX" marking.
- Hold ignition key for at least 30 seconds in position "1" without starting engine.
This clears a fault entry in the RAM
This prevents the brake wear indicator lamp from lighting up again.
Necessary preliminary tasks:
- Remove wheels. Refer to 36 10 300 REMOVING OR INSTALLING FRONT OR REAR WHEEL .
Lift out retaining spring (1).
Left:
Disconnect plug connection for brake lining wear sensor. If necessary, replace brake lining wear sensor.
Remove plastic plugs (2).
Lift brake hose out of bracket.
Release guide screws (1) with special tool 34 1 080. Withdraw brake caliper backwards.