51 43 251 Removing and installing or replacing trim from rear left or right roof pillar

WARNING: This page is about a different car, the 2001 BMW 740iL and 2001 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Version with head airbag: Follow safety instructions for working on cars with airbag systems, refer to 51 00 ... SAFETY INSTRUCTIONS FOR WORKING ON CARS WITH AIRBAG SYSTEMS

CAUTION: Do not use sharp-edged tools to remove trim (risk of damage to head air bag).

Lever out top interior light, take out towards top and disconnect plug connection.

Fig 1: Identifying Lever Out Top Interior Light

Version with head airbag in rear compartment:

Can be identified by airbag emblem (1).

Unfasten screws (2).

Take out panel (3) towards inside at top.

Installation:

Tightening Torque, refer to 51 43 1AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 740I & 740iL - E38 .

Fig 2: Tightening Torque

Version without head airbag in rear compartment:

Unfasten screws.

Take out panel towards inside at top.

Installation:

Tightening Torque, refer to 51 43 1AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 740I & 740iL - E38 .

Fig 3: Identifying Head Airbag In Rear Compartment

Only replacing:

Remove insulating mat (1) and glue to new C-pillar finisher.

Fig 4: Removing Insulating Mat And Glue To New C-Pillar