65 52 530 Removing and installing/replacing LC display for on-board monitor

Remove on-board monitor, refer to 65 52 510 REMOVING AND INSTALLING ON-BOARD MONITOR

CAUTION: Place trim panel on special tool 12 7 192 (anti-static mat) and ground in order to avoid a static charge.

Unfasten screws. Turn over frame.

Fig 1: Turning Over Frame

Unfasten screws. Slide LC display out towards front.

Fig 2: Sliding LC Display Out Towards Front

CAUTION: Cover flat tape (1) with installation cover (2) and then slide in LC display.

Fig 3: Covering Flat Tape With Installation Cover

Install LC display and insert screws loosely. Fit trim panel; while doing this, make sure plug is correctly seated on button board. Press LC display against frame (gap between LC display and frame must be the same all round), then tighten down screws.

Fig 4: Installing LC Display And Inserting Screws