65 52 510 Removing and installing on-board monitor

Release screws.

Fig 1: Releasing Screws

Release upper plastic nuts and remove wooden finisher.

Fig 2: Releasing Upper Plastic Nuts And Removing Wooden Finisher

Installation:

Fit outer plastic nuts with knurling (2) facing trim and inner plastic nuts with hexagon heads (1) facing trim (risk of damage to passenger airbag).

Fig 3: Fitting Outer Plastic Nuts With Knurling (2) Facing Trim And Inner Plastic Nuts With Hexagon Heads (1) Facing Trim

Remove top left wooden finisher by pulling upwards.

Fig 4: Removing Top Left Wooden Finisher By Pulling Upwards

Remove screws and take off plate.

Fig 5: Removing Screws And Taking Off Plate

Unfasten screws and pull on-board monitor forwards to remove.

Fig 6: Unfastening Screws And Pulling On-Board Monitor Forwards To Remove

Remove plug and unfasten wiring harness from clips.

Fig 7: Removing Plug And Unfastening Wiring Harness From Clips