11 22 513 Replacing roller bearing for dual-mass flywheel

Special tools required:

NOTE: For special tools, refer to ENGINE - SPECIAL TOOLS .

NOTE: Flywheel removed!

Using hydraulic press (1) and special tool 21 2 051, press out dual-mass flywheel downwards on engine side.

IMPORTANT: Risk of damage: Roller bearing must not be driven out.

Fig 1: Identifying Special Tool 21 2 051

Courtesy of BMW OF NORTH AMERICA, INC.

Push roller bearing (2) onto special tool 21 2 052.

Fig 2: Identifying Special Tool 21 2 052)

Courtesy of BMW OF NORTH AMERICA, INC.

Using hydraulic press (1), press roller bearing into dual-mass flywheel as far as it will go on clutch side.

IMPORTANT: Risk of damage: Observe press-in instruction:

Roller bearing must not be driven in.
Roller bearing mounting force/travel monitored:
Min. 2000N 1 mm before end of pressing in.

Max. 15000N during entire press-in procedure.