11 36 575 Replacing solenoid valve for exhaust side on VANOS adjustment unit
Special tools required:
NOTE:
For special tools, refer to ENGINE - SPECIAL TOOLS
.
- 11 6 420
Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Check stored fault messages
- Switch off ignition
E85 only:
- Remove fluid tank for windshield washer system. See 61 71 061 REPLACING FLUID TANK FOR WINDSHIELD WASHER SYSTEM
Unlock plug (1) and remove. Cut through cable tie (2).
NOTE:
Once it has been removed, oil drips from the solenoid valve.
Have a cleaning cloth ready.
Make sure no oil drips onto the belt drive. Remove any remnants of oil immediately with cleaning cloth.
Release solenoid valve with special tool 11 6 420.
Installation:
Tightening torque, refer to 11 36 1AZ in ENGINE - TIGHTENING TORQUES .
Now clear the fault memory.