LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2000 >> 323Ci 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine - Repair >> Flywheel >> 11 22 500 Removing and installing or replacing flywheel (M52 / S52 / M52TU / M54 / S54)

11 22 500 Removing and installing or replacing flywheel (M52 / S52 / M52TU / M54 / S54)

Special tools required: 

NOTE: For special tools, refer to ENGINE - SPECIAL TOOLS .

Lock flywheel with special tool 11 2 170.

Fig 1: Identifying Special Tool 11 2 170
G03163986Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws and remove flywheel.

Fig 2: Unfastening Screws And Removing Flywheel
G03163987Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. Check dowel sleeve for damage and correct installation position.
Fig 3: Checking Dowel Sleeve
G03163988Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. Position of dowel sleeve (1) in dual-mass flywheel is identified by two notches next to associated bolt hole.
Fig 4: Positioning Of Dowel Sleeve In Dual-Mass Flywheel
G03163989Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. Clean thread and install new micro-encapsulated screws.
    Fig 5: Installing New Micro-Encapsulated Screws
    G03163990Courtesy of BMW OF NORTH AMERICA, INC.
  2. Tightening torque, refer to 11 22 1AZ in ENGINE - TIGHTENING TORQUES .
scientia non olet · About LEMON Manuals