Drive Axle Shafts (Rear, 2 Wheel Drive Models): Installation

1. Pull in output shaft using special tools (33 2 115/116/119). See Fig 1.
2. On M3, use special tools (33 2 115/116/118). See Fig 2.
3. On all models, install axle shaft to vehicle, positioning inner CV joint on final drive flange. Install CV joint-to-final drive flange bolts and tighten to specification. See TORQUE SPECIFICATIONS .
4. Coat threads and contact face of NEW collar (hub) nut with oil and install nut. Secure by caulking at flat area of output shaft. Tighten nut to specification. See TORQUE SPECIFICATIONS .
5. Install NEW collar nut retaining plate and install hub dust cover. On Z3, drive in new retaining plate with special tool (33 1 020). See Fig 3.
6. Install rear wheel.

Fig 1: Using Special Tool (33 2 119)

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Using Special Tool (33 2 118)

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Using Special Tool (33 1 020)

Courtesy of BMW OF NORTH AMERICA, INC.