LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2000 >> 323Ci 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Axle Shafts >> Front/Rear Drive Axle - Repair (2WD & 4WD) >> Removal & Installation >> CV Joint Boot (Rear) >> Removal

CV Joint Boot (Rear): Removal

NOTE: When replacing, use a complete CV joint boot repair kit. Kit will include a new boot, clamps, special lubricant and inner CV joint circlip.
  1. Remove axle shaft. See DRIVE AXLE SHAFTS (REAR) .
  2. Press off sealing cover (1). See Fig 1.
  3. Release hose clamps (2). Press off cap (3) with rubber boot. Remove circlip (4). See Fig 2.
  4. Place axle and CV joint on a hydraulic press so CV joint inner hub is supported on press. See Fig 3. Using a suitable adapter, press axle shaft from CV joint.
  5. Clean all lubricant off axle shaft splines and inner CV joint splines. Check joint for dirt or damage.
    6. NOTE: Do not disassemble joint if not absolutely necessary.
  6. If the joint has to be disassembled, mark positions of ball hub, ball cage and joint with respect to each other using an electric inscriber. See Fig 4.
  7. Release hose clamps (5 and 6). Pull rubber gaiter over splined shaft. See Fig 5.
Fig 1: Locating Sealing Cover
G00123104Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Identifying Dust Cover Components
G00123105Courtesy of BMW OF NORTH AMERICA, INC.
Fig 3: Supporting Inner CV Joint Hub On Press
G00078963Courtesy of BMW OF NORTH AMERICA, INC.
Fig 4: Marking Positions Of Dust Cover Components
G00123108Courtesy of BMW OF NORTH AMERICA, INC.
Fig 5: Locating Hose Clamps
G00123106Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals