Placing a Call

A call can be placed in several different ways:

1. Using the keypad or address book of the mobile phone and depressing the send button on the phone.
   NOTE: Some phones may ask if the call is to remain within the phone. Refer to the users manual of the phone for specific instructions on disabling this feature.
2. Depressing the R/T button on the steering wheel, then scrolling (using the ™ or ™ buttons) through the address book of the phone that is linked to the ULF, until the desired number is displayed on the radio or display screen and then depressing the send/receive ™ button on the steering wheel or center console to place the call.
3. Depressing the ™ button on the steering wheel until an audible "beep" is heard through the vehicle speakers, at this point a call can be placed by using the following voice commands:
   • "Dial number" or "Dial phone":
   • After the system asks for a number say the number.

     Example: "123 456 7890"; the system will repeat the number requested once you stop speaking momentarily, the number may also be displayed depending on the vehicle and equipment/accessories installed.

   • "Dial":
     NOTE: Once the dial command is given the number will be displayed on the dis play screen or radio; plus it will always be displayed on the mobile phone after a call is placed.
4. Briefly depressing the ™ button on the steering wheel will redial the last number dialed.

For more information on using voice commands refer to the " Owner's Manual for Voice Input System. The Convenient Alternative to Manual Control" (P/N 84 11 027 942)