51 48... Removing and installing/replacing sound insulation in rear door, left or right

Remove rear door trim,

refer to 51 42 000 REMOVING AND INSTALLING REAR LEFT OR RIGHT DOOR TRIM PANEL

If necessary, remove airbag module in rear door,

refer to SIDE AIR BAG MODULE .

Unfasten plug connection (1).

Release screws (2) and remove speaker unit.

Remove inside door handle on rear door,

refer to 51 22 225 REMOVING AND INSTALLING/REPLACING INSIDE DOOR OPENER OF REAR LEFT OR RIGHT DOOR .

Fig 1: Removing Speaker Unit

CAUTION: Do not kink fiber optics cable. The bending radius of the fiber optics cable must not be less than 20 mm.

Detach central light source (1) from retainer (2).

Disconnect plug connection (3) and detach fiber optics cable (4) from central light source.

Fig 2: Detaching Central Light Source From Retainer

Release screws (1) and remove holder for central light source (2).

Fig 3: Removing Central Light Source Holder

Release cable ties (1) on wiring harness (2) and on cable (3). Disconnect plug connection (4).

Fig 4: Releasing Cable Ties On Wiring Harness & On Cable & Disconnecting Plug Connection

Release expansion rivets (1) and (2).

Release screw (3) and unhook cable (4).

Fig 5: Unhooking Cable

Release expansion rivets (1).

Fig 6: Releasing Expansion Rivets

Using special tool 00 9 317 (trim panel wedge), lever out sealing bead (1) of sound insulation (2) completely or if necessary partially.

Fig 7: Levering Out Sealing Bead Of Sound Insulation

Installation:

In event of replacement or partial detachment, lay butylene tape (sourcing reference: BMW Parts Service) on inner door plate or sound insulation.
Seal cable penetrations with butylene tape.

NOTE: Position of butylene tape (1)on inner door plate.

Fig 8: Identifying Position Of Butylene Tape On Inner Door Plate

NOTE: Position of butylene tape (1) on sound insulation (2).

Fig 9: Identifying Position Of Butylene Tape On Sound Insulation

E38 long version only:

NOTE: Position of butylene tape (1) on inner door plate.

Fig 10: Identifying Position Of Butylene Tape On Inner Door Plate (E38 Long Version Only)

E38 long version only:

NOTE: Position of butylene tape (1) on sound insulation (2).

Fig 11: Identifying Position Of Butylene Tape On Sound Insulation (E38 Long Version Only)

CAUTION: When working with adhesive cleaners in enclosed rooms: Ensure room is well ventilated.
The adhesive areas must be dry and free from dust and grease.
After cleaning, do not touch the adhesive areas with bare hands.

If necessary, clean the specified adhesive area with adhesive cleaner (sourcing reference: BMW Parts Service).

Air drying time: 1 minute

Lay butylene tape with a diameter of 6 mm (sourcing reference: BMW Parts Service) in specified adhesive area.

Heat butylene tape (hot air blower) and press down firmly on sound insulation all round.

Contact pressure with hand roller: approx. 30 N/cm² Manual contact pressure: approx. 10 N/cm²

NOTE: Firm thumb pressure has approx. 50 N/cm²