51 11 170 Replacing body molding for left or right bumper

Lever out body molding with special tool 00 9 321 (fishbone) first at front and then at side.

Version without Park Distance Control (PDC):

Remove body molding.

Version with Park Distance Control (PDC):

Disconnect plug connections on ultrasonic sensors and remove body molding.

Fig 1: Removing Body Molding

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, lever chrome strip (1) out of clips (2) of body molding and remove.

Fig 2: Removing Lever Chrome Strip Out Of Clips Of Body Molding

Courtesy of BMW OF NORTH AMERICA, INC.

Version with PDC:

Lever out catches (1) and remove ultrasonic sensors (2).

Remove catches (3) and mounts (4) from body molding (5).

Fig 3: Removing Catches And Mounts From Body Molding

Courtesy of BMW OF NORTH AMERICA, INC.