Electrical Contact Enhancer

Stabilant 22A evaporates and leaves a thin polymer film which is conductive between the mating surfaces, while staying non-conductive between adjacent pins. At the same time it prevents the formation of any further harmful deposits.

ELECTRICAL CONTACT ENHANCER SPECIFICATION

Wurth

Part No. 893622 (Stabilant 22A)

NOTE: Stabilant 22A must not be used on Oxygen Sensor connectors. To function, oxygen sensors require a flow of oxygen through the terminal connector to the sensor element. Stabilant 22A will affect this flow of oxygen, and will result in irreparable damage to the sensor.

NOTE: Stabilant 22A must not be used on plug connectors which carry fiber optics. Stabilant 22A may migrate to the fiber optic and attenuate the optical signal.

See S.I. Bulletin B 61 05 00.