51 46 000 Removing and installing/replacing trim for oddments tray (back shelf)

Necessary preliminary tasks: 

• Remove both panels for rear roof pillar (C-pillar finishers).

  Version without electric rear seat adjustment:

• Remove both rear seat backrests.

  Version with electric rear seat adjustment:

• Unclip trims on rear seat backrests at top.

Open top tray on center console.

Lift out detent and pull tray upwards to remove.

Version with rear window roller blind only:

If necessary, release screws and nuts in luggage compartment.

Installation: 

1. Tightening torque, 51 46 1AZ.
   Fig 2: Releasing Screws & Nuts In Luggage Compartment

   

Version with rear window roller blind only:

If necessary, disconnect plug (1) and expose cable (2).

Lift out expanding rivet and pull rear shelf forwards to remove.

If necessary, remove or replace rear window roller blind:

If necessary, release nuts.

Installation: 

1. Tightening torque, 51 46 2AZ.
   Fig 5: Removing Rear Window Roller Blind

   

If necessary, lever out trims (1) on left and right. Feed out rear window roller blind (2) and remove.

Installation: 

Check function.

Replacement only: 

Lift out detents and remove both decorative grilles.