Special tools required:
NOTE:
For Special Tools, see PROPELLER SHAFT - SPECIAL TOOLS - 740i & 740iL - E38
.
- 00 5 500
- 11 1 310
- 11 2 030
Necessary preliminary tasks:
- Remove propeller shaft. Refer to 26 11 000 REMOVING AND INSTALLING COMPLETE PROPELLER SHAFT .
Pack centering bore fully with viscous grease.
Drive special tool 11 1 310with a plastic hammer into centering bore.
The center mount is forced out by applying pressure to grease fill (1).
If necessary, top up grease repeatedly.
NOTE:
To drive out the mount, you can also fill the centering bore with water instead of grease.
Remove grease/water from mount bore.
Drive in centering (1) with special tools 00 5 500 and 11 2 030 until protrusion (A) is reached.