34 21 200 Removing and installing or replacing brake linings on both rear disk brakes: Notes
Special Tools Required:
NOTE:
For Special Tools, see BRAKE - SPECIAL TOOLS - 740i & 740iL - E38
.
- 34 1 050
- 34 1 080
NOTE:
After completing work:
- Fully depress brake pedal several times so that brake linings contact brake discs.
- When installing new brake linings at front and rear axles, brake fluid level must be brought up to "MAX" marking.
- Hold ignition key for at least 30 seconds in position "1" without starting engine.
This clears a fault entry in the RAM.
This prevents the brake wear indicator lamp from lighting up again.
Remove wheels. Refer to 36 10 300 REMOVING OR INSTALLING FRONT OR REAR WHEEL .
Remove plastic plugs (1).
Right side:
Disconnect plug connection for brake lining wear sensor.
If necessary, replace brake lining wear sensor.
Release guide screws (2) with special tool 34 1 080.