34 41 220 Removing and installing / replacing all brake shoes of the parking brake: Installation:

Check recoil springs and replace if necessary.

Twist clamping pins with special tool 34 4 000 through 90° and disconnect.

Remove brake shoes.

Fig 1: Twisting Clamping Pins With Special Tool

NOTE: Figure illustrates right side: left side is mirror image of this.

Note installation position of adjusting screws (1) and (2).

Coat thread of bush (1) and screw (2) with grease.

Fig 1: Coating Thread Of Bush And Screw With Grease