13 54 060 Removing and installing or replacing throttle body (ASC+T) (M60, M62)

Interrogate fault memory of the ASC+T control unit.

Switch off ignition.

Remove hose (1).

Unfasten hose clip (2).

Remove gaiter.

Fig 1: Removing Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect connector.

Fig 2: Disconnecting Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect cable.

Installation

Fig 3: Disconnecting Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (1) to (3).

Remove throttle body.

Fig 4: Identifying Throttle Body Unfasten Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Replace gasket (1).
Interrogate fault memory of ASC+T control unit, check fault messages stored in memory, rectify faults and clear the fault memory.

Fig 5: Locating Throttle Body Gasket

Courtesy of BMW OF NORTH AMERICA, INC.