26 12 001 Replacing complete propeller shaft center bearing (constant-velocity joint): Installation:
Thread free from grease.
When pushing shaft together, make sure that markings match up.
Insert bolt (1) with thread locking liquid, refer to BMW Parts Service.
Tightening torque, refer to 26 11 5AZ PROPELLER SHAFT ASSEMBLY .
Remove shim and dust gaiter.
Pull off center bearing with special tool 00 7 500 / 33 1 307 and commercially available puller.
Drive new center bearing firmly home with special tool 24 0 090or 24 1 050.
NOTE:
Bearing inside diameter 30 mm, use special tool 24 0 090. Bearing inside diameter 35 mm, use special too24 1 050.