61 13 ... Crimping optical fibres
Special Tools Required:
- 61 4 320
To crimp optical fibres, use pliers 61 4 321 (1) in conjunction with crimping head 61 4 323 (2) from crimping set 61 4 320.
NOTE:
Pliers (1) open automatically as far as they will go when handles are pressed together.
Fig 1: Identifying Pliers 61 4 321 (1) In Conjunction With Crimping Head 61 4 323 (2) From Crimping Set 61 4 320
Move contact guide by means of stop lever (1) into corresponding position (pin contact or jack).
Open pliers (2).
Place pin contact or jack (1) in crimping head and secure with locking lever (3).
NOTE:
Follow procedure for cutting and stripping insulation from optical fibres.
Insert stripped optical fibre (1) as far as it will go into pin contact or jack (2).
Close pliers (3) fully.
Open pliers (3) and locking lever (4).
Remove optical fibre (1).
IMPORTANT:
Make sure optical fibre is correctly seated in jack. Right (A): End of optical fibre (1) must be flush with tip of pin contact (2). Wrong (B): End of optical fibre (1) is not flush with tip of pin contact (2).