Removal & Installation
- Remove upper control arm. See UPPER CONTROL ARM
.
- Press out rubber mount with special tool (33 3 351/352). See Fig 1
.
- Place new rubber mount at chamfered end of control arm bore. Longer collar (A) of rubber mount must point upwards. Distance (A) is .7" (17 mm). See Fig 2
.
- Press in rubber mount with special tool (33 3 351/352) so that it is flush.
- Install upper control arm. See UPPER CONTROL ARM
.
Courtesy of BMW OF NORTH AMERICA, INC.
Courtesy of BMW OF NORTH AMERICA, INC.