Valve Body: Reassembly

To reassemble, reverse disassembly procedure. Lubricate all components with ATF. Ensure flat face of throttle valve retaining clip faces away from valve spring and flat side of modulator valve retaining clip faces away from valve spring. When installing modulator valve cover plate, ensure plate lug engages into kickdown valve.

To reassemble, reverse disassembly procedure. Lubricate all components with ATF. Ensure thermo valve is installed so front face of valve faces thermo switch.

1. To reassemble, reverse disassembly procedure. Lubricate all components with ATF. Ensure clutch "F" valve engages in clutch "F" damper spring seat and flat face of retaining clip faces away from damper.
2. Ensure restrictors are installed in rear valve body and remain in original positions and directions. Ensure when front valve body is inverted, restrictors and ball remain in front valve body.

1. To reassemble, reverse disassembly procedure. Lubricate all components with ATF. Ensure flat face of clutch "B" valve retaining clip faces away from cover plate.
2. Ensure clutch "D" valve retaining clip flat side faces damper/spring. Ensure clutch "C" valve retaining clip faces cover plate. Install and align plastic ball and restrictors on front valve body. Set valve body aside.