LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1988 >> 325is Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Repair (E30) >> Bleeding Brake System >> Bleeding Procedures >> Bleeding Brakes

Bleeding Brakes

  1. Connect bleeder on brake fluid tank. Conform with operating instructions supplied with bleeder. Charging pressure must not exceed 28 psi (2 bar).
  2. Connect bleeder hose with bottle on bleeder screw of right rear brake circuit. See .Fig 1
  3. Unscrew bleeder screw.
  4. When escaping brake fluid is without air bubbles tighten bleeder screw.
  5. Repeat procedure on left rear, right front, then left front.
Fig 1: Connecting Bleeder Hose
G00123093Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals