LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1986 >> 735i Standard >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Wheel Bearing >> Removal

Wheel Bearing: Removal

  1. Raise and support vehicle. Disconnect output shaft at drive flange and suspend out of way. Remove brake caliper bolts and brake caliper. Remove hex head screw and remove rotor.
  2. Remove lock plate. Remove collar nut with Nut Remover (33 4 000). Pull off drive flange. Install collar nut flush with end of shaft. Knock shaft out using soft mallet.
  3. Remove snap ring and remove wheel bearing using puller. Remove inner bearing shell from rear axle shaft using puller, if necessary.
scientia non olet · About LEMON Manuals