LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1984 >> 733i Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engines >> Transmission, Engine, Manifolds & Cylinder Head >> Manual Transmission >> Removal

Manual Transmission: Removal

  1. Remove exhaust system and support brackets from vehicle. Disconnect drive shaft at rear of transmission. Remove heat shield from center support bearing.
  2. Remove center support bearing bracket. Lower drive shaft at center support bearing and pull drive shaft from transmission. On 533i, 633CSi, and 733i models, remove speed and reference mark sensors.
  3. On all models, remove clutch slave cylinder, leaving line connected. Remove speedometer cable and disconnect plug from back-up light switch.
  4. Pull up boot from floor shift lever, remove circlip and pull shift lever up and out. Support transmission and remove crossmember. Remove transmission.
scientia non olet · About LEMON Manuals