LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1984 >> 733i Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engines >> Transmission, Engine, Manifolds & Cylinder Head >> Manual Transmission >> Installation

Manual Transmission: Installation

  1. To install, reverse removal procedure. When installing drive shaft, use new lock nuts at rubber coupling. Only tighten nuts (never bolts) to avoid stress on coupling.
  2. When installing drive shaft, push center support bearing forward .08" (2.0 mm) to preload bracket, then tighten nuts.
  3. When installing speed and reference mark sensors, note that Black plug of speed sensor faces ring gear. Gray ring of reference mark sensor faces flywheel. If plugs are reversed, engine will not start.
scientia non olet · About LEMON Manuals