LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1984 >> 733i Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engines >> Transmission, Engine, Manifolds & Cylinder Head >> Automatic Transmission >> Installation

Automatic Transmission: Installation

  1. To install transmission and remaining components, reverse removal procedures. Before installing transmission, ensure torque converter is properly seated.
  2. When installing drive shaft, push center support bearing forward .08" (2.0 mm) to preload bracket, then tighten nuts.
  3. When installing sensors, note that Black plug of speed sensor faces ring gear. Gray ring of reference mark sensor faces flywheel. If plugs are reversed, engine will not start.
scientia non olet · About LEMON Manuals