LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1982 >> 733i Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 528E, 633CSI & 733I 6-Cylinder >> Pistons, Pins & Rings >> Piston & Rod Assembly >> Removal

Piston & Rod Assembly: Removal

  1. Remove cylinder head, oil pan and oil pump. If necessary, mark rod and rod cap for cylinder identification, then remove rod cap.
  2. Remove ridge at top of cylinder bore. Push piston and rod assembly out top of block. Install rod cap on connecting rod from which removed.
  3. If replacing pistons or rods, be sure they are in the same weight class as existing piston or rods.
scientia non olet · About LEMON Manuals