LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1982 >> 733i Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 528E, 633CSI & 733I 6-Cylinder >> Pistons, Pins & Rings >> Oil Pan >> Removal (633CSi)

Removal (633CSi)

  1. Drain engine oil and remove wire from oil level switch (if equipped). Remove steering stabilizer. Remove power steering pump with hoses connected. Remove mounting bracket attached to oil pan and front cover.
  2. Remove oil pan bolts. Lower pan and move toward front of engine. Turn crankshaft until No. 6 connecting rod is above crankcase sealing surface.
  3. Move oil pan toward right side of engine and remove. If necessary, raise engine at clutch housing with a jack to allow clearance for pan removal.
scientia non olet · About LEMON Manuals