LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1982 >> 733i Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 528E, 633CSI & 733I 6-Cylinder >> Engine & Cylinder Head >> Manual Transmission >> Removal

Manual Transmission: Removal

  1. Remove exhaust system and support brackets from vehicle. Compress rubber coupling with compressing strap (26 1 012), then disconnect propeller shaft at rear of transmission.
  2. Remove heat shield from center support bearing. Remove center support bearing bracket. Lower propeller shaft at center support bearing and pull propeller shaft from transmission.
  3. Remove clutch slave cylinder, leaving line connected. Remove speedometer cable and disconnect plug from back-up light switch.
  4. Pull up boot from floor shift lever, remove circlip and pull shift lever up and out. Support transmission and remove crossmember. Remove transmission.
scientia non olet · About LEMON Manuals