LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1982 >> 733i Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 528E, 633CSI & 733I 6-Cylinder >> Camshaft >> Timing Belt Cover >> Installation

Timing Belt Cover: Installation

  1. Clean gasket mating surfaces. Coat oil pan-to-cover gasket with gasket sealer. Install centering tool (11 2 211) on crankshaft and centering tool (11 2 212) on intermediate shaft to align front cover.
  2. Using new gasket, install and tighten timing belt cover. Note that lettering on crankshaft sprocket must face forward when installing. Install remaining components in reverse order of removal procedures.
scientia non olet · About LEMON Manuals