LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1978 >> 630CSi Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5301, 633CSI & 733I 6 Cylinder >> Engine, Cylinder Head & Manifolds >> Manual Transmission

Manual Transmission

  1. Pull up boot from shift lever, remove circlip and pull shift lever up and out. Remove exhaust pipe support bracket. Disconnect drive shaft at transmission, loosen threaded coupling of drive shaft at rear of center support bearing.
  2. Remove center support bearing and pull drive shaft from transmission. Remove speedometer cable and disconnect backup light switch connection. Disconnect transmission from clutch housing. Support front of engine, remove transmission crossmember and transmission.
  3. To install, reverse removal procedure. When installing drive shaft, push center support bearing forward 0.08" (2 mm) to preload bracket, and tighten nuts.
scientia non olet · About LEMON Manuals