LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1978 >> 630CSi Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 5301, 633CSI & 733I 6 Cylinder >> Crankshaft Main & Connecting Rod Bearings >> Camshaft >> Removal

Crankshaft Main & Connecting Rod Bearings: Camshaft: Removal

  1. With cylinder head removed, unscrew EGR valve nut with tool (11 7 000), detach EGR line and remove coolant hose. Loosen bolts attaching oil distribution line to rocker arm supports and remove line. Loosen all valve adjustments to maximum clearance position.
  2. Rotate camshaft from TDC position of No. 1 cylinder toward intake approximately 0.59" (15 mm) and install compression tool (11 1 060). Tighten exhaust side nuts on tool to stop, then intake side nuts. Remove camshaft retaining bolts and pull out camshaft
scientia non olet · About LEMON Manuals