LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1973 >> 3.0CS _NA_, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> BMW Engines - 2500, 2800, 3.0 & BAVARIA 6 Cylinder >> Oil Pan Removal

Oil Pan Removal

  1. Remove protective cover from under engine, drain oil and remove front suspension stabilizer. Loosen alternator and remove belt.
  2. Remove power steering pump (if equipped) from bracket but do not disconnect hoses. Remove bolt securing power steering pump bracket to side of oil pan.
  3. Loosen power steering bracket until oil pan bolts can be reached. Detach support bracket above slave cylinder from crankcase. Rotate crankshaft until number six connecting rod is above oil pan mating surface of crankcase.
  4. Remove oil pan retaining bolts, lower front of oil pan, turn rear of pan towards support bracket and remove oil pan. To install, reverse removal procedure. Clean mating surfaces and apply Atmosit Sealer to junctions of crankcase and timing cover, and flywheel end cover.
scientia non olet · About LEMON Manuals