LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1970 >> 2002 _NA_, Standard Trans >> Repair and Diagnosis >> Transmission >> Clutches - (4 Cylinder Engine) Hydraulic Clutch >> Removal & Installation >> Clutch Release Bearing & Fork

Clutch Release Bearing & Fork

  1. Remove transmission as previously outlined. Remove clutch slave cylinder from mount in transmission. Lift clutch fork retaining spring over ball stud.
  2. Remove clutch fork and release bearing out through front of transmission. Pull release bearing off of clutch fork.
  3. To install, reverse removal procedure. Apply Molykote Longterm 2 lubricant to release bearing clips and ball stud.
scientia non olet · About LEMON Manuals