Overview - Transmission Housing Bearing
- Circlip
- Pinion Roller Sleeve
- Bearing "I"
- Refer to Transmission Housing, Servicing .
- Transmission Housing
- Seal
- For the transmission output shaft.
- Only on vehicles with an all-wheel drive clutch
- Refer to TRANSMISSION OUTPUT SHAFT SEAL, REPLACING
- Cap
- Refer to Transmission Housing, Servicing .
- Fluid Catch Tray
- Always replace after removing
- Input Shaft Ball Bearing
- Bearing "E"
- Installation position: the surrounding groove points to the transmission housing
- Refer to Transmission Housing, Servicing .
- Circlip
- Installation position: the bevel of the circlip faces away from the ball bearing, while the smooth side faces the ball bearing
- Roller Sleeve for the Output Shaft
- Bearing "F"
- Refer to Transmission Housing, Servicing .
- Circlip
- Different versions
- Refer to the Electronic Parts Information (ETKA) for the allocation.
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1 | -1- through -9- | Install by hand evenly until the bolt head contacts the transmission housing |
| 2 | -1- through -9- | 10 Nm + 90° |
| 3 | -Arrow- | Tighten the remaining bolts clockwise to 10 Nm + 90° |
| Steps | Bolts | Tightening Specification |
|---|---|---|
| 1 | -1- through -5-, bolt 6 without sleeve | Insert the centering sleeves -A- all the way |
| 2 | -1- through -6- | Install by hand evenly until the bolt head contacts the transmission housing |
| 3 | -1- through -6- | Steel bolts: 15 Nm + 90° aluminum bolts: 10 Nm + 120° |