Pinion Roller Sleeve, Replacing: Procedure

-- Remove the circlip for the pinion roller sleeve.

The transmission housing can be attached to the Transmission Support :VW353  for this procedure.

-- Remove the roller sleeve -1- with Internal Puller (Kukko 21-3) : VAS 251 607  -2- or KUKKO 21-3 and Counter Support (Kukko 22/1) : VAS 251 621  -3- or KUKKO 22-1.

Fig 1: Remove the pinion roller sleeve -1-

Courtesy of AUDI OF AMERICA, LLC

-- Position the roller sleeve -1- with the lettered side (larger panel thickness) to the Seal/Bearing Installer - Multiple Use :30-21  -3-.

Fig 2: Press in the Pinion Roller Sleeve -1-

Courtesy of AUDI OF AMERICA, LLC

-- Press in the pinion roller sleeve -1- while using the following tools for this purpose:

• 2 -  Press Piece - Multiple Use :VW412 
• 3 -  Seal/Bearing Installer - Multiple Use :30-21 

-- Install the circlip for the pinion roller sleeve.