Output Shaft Roller Bearing, Replacing: Procedure

-- Remove the bolts -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bearing shell -1-.

-- Break off the tab -arrow- of the oil guide shell.

-- Remove the output shaft roller bearing -1-. Use the following tools to do this:

Fig 1: Roller Sleeve for the Output Shaft -1-, Extend, Vehicles without Self-Locking Center Differential

Courtesy of AUDI OF AMERICA, LLC

• 2 -  Internal Puller (Kukko 21-7) : VAS 251 615  or KUKKO 21-7
• 3 -  Counter Support (Kukko 22/2) : VAS 251 623  or KUKKO 22-2
• 4 -  Bearing Installer - Wheel Bearing :3144 

-- Insert a new oil guide shell -2-.

Fig 2: Roller Sleeve for the Output Shaft -1-, Driving In, Vehicles without Self-Locking Center Differential

Courtesy of AUDI OF AMERICA, LLC

-- Drive in the output shaft roller bearing -1- using the Seal Installer - Gearbox : 3295  .

Conditions

• Installation position of the roller bearing: the surrounding groove -arrow- points to the Seal Installer - Gearbox :3295  .

-- Lay the bearing shell -1- onto the roller bearing.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -2- to the tightening specification.