Output Gear Of The Spur Gear Unit, Removing And Installing: Removing

-- Remove the hydraulic pressure reservoir. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .

-- Remove the circlip from the pinion.

-- Install the puller -3- with nuts -4- on the output gear -1-.

Fig 1: Slide off the Output Gear -1- of the Drive Wheel from the Pinion.

Courtesy of AUDI OF AMERICA, LLC

Conditions

• The puller with nuts -4- must not touch a housing rib!

-- Warm up the output gear -1- to approximately 100°C (212 °F) by using a hot air gun.

-- Counterhold on the puller -arrow- when removing.